R/C Tech Forums - View Single Post - Losi XXX-S
Thread: Losi XXX-S
View Single Post
Old 06-14-2004, 09:21 PM
  #11101  
John L
Tech Apprentice
 
John L's Avatar
 
Join Date: Dec 2003
Location: Fountain Valley, CA
Posts: 81
Default Building A Ultimate XXX-S

Here is list what I did so far since year 2001 ORG XXX-S,
Any hting on the list you can find made my car better or worse? (any comment?)

1: Moved all my electronics forward to better balance chassis
2: Installed fan and heat sink
2: Milled down front shock upper bushings to give FR shocks better angle
3: Got rid of servo saver
4: bought many packs of GP3300 (from Sanyo 3000)
5: Start deep cycle my packs for better punch (more story later)
6: Installed set screws on rear suspension mounts to hold arms tight.

7: Dremel sharp droop screws end point round to keep droops consistent

8: Installed 0.5 Left rear hub carrier on right and 1 degree rear right hub on left side to have equal rear toe in

9: graphite conversion
10: Ceramic bearings
11: ball bearings on bellcranks
12: Aluminum CVDs
13:Kevlar spur
14: HD long black belt
15: Cut down Axles and installed trinity low profile lock nuts to save rotating mass/unsprung weight
16:Swiss cheesed front bumper
17:Full set of titanium screws
18:Titanium turnbuckles
19: last but not least Got ALFA/Mazda 6 body! (what a difference!)
20: gold plated hinge pins
กก

Last edited by John L; 06-15-2004 at 01:47 AM.
John L is offline