R/C Tech Forums - View Single Post - Team Associated TC6 Thread
Thread: Team Associated TC6 Thread
View Single Post
Old 07-02-2011, 08:16 PM
  #3098  
P.I.M.P
Tech Regular
iTrader: (14)
 
P.I.M.P's Avatar
 
Join Date: Jul 2009
Posts: 465
Trader Rating: 14 (100%+)
Default
Originally Posted by Verndog
Not sure where your question is but these are the basics. Put them on just like the AE blocks, only while tightening the main block screw into bulkhead you need to hold the block down to rest on the top set screw to locate. After tightening there should be tension on the top 1.5mm driver screw. Then lock the pin set screw againt hinge pins and drive like mad.
hi verndog,

just a question is there any chance of getting some pins made that are the same length as tc6 arm pins and thickness that are threaded both ends so i can mount like this.cheers

Click image for larger version Name: IMG_0341.jpg Views: 475 Size: 293.2 KB ID: 775913

Click image for larger version Name: IMG_0340.jpg Views: 378 Size: 297.2 KB ID: 775914
P.I.M.P is offline  
Reply