View Single Post
Old 06-30-2011, 12:09 AM  
curacing2
Tech Addict
 
curacing2's Avatar
 
Join Date: May 2011
Location: New Zealand Auckland
Posts: 594
Default

A problem i see with some starterboxes engagement point when you press down on the lid is the wheel doesn't spin up before the flywheel hits it or its just starting to roll on contact with the flywheel, and this is especially bad on a very tight motor...the starter wheel stalls under load from the tight motor but the batteries keep feeding the power making all the electrics get hot.

I found my new GO starterbox had an adjustment for this and its made a big difference hitting the wheel when its spinning at full rpms.
curacing2 is offline   Reply With Quote