Originally Posted by
Manson
I just received my tc6 kit today but i have a little problem with my lowerdeck...
It s a lot tweaked
When put my fingers on the front of the lowerdeck, the rear up 2 mm
Tested on a glass, my smokem 416 fx don't have any tweak on it...
This was without any parts fixed on the lowerdeck for both.
Can i do ? warantly ? is it right to have this tweak without parts ?
First if you used the stock kit screws they will sit below chassis and make it appear tweaked. Remove and replace, then check the front bumper plastic bracket, that sits a bit low also. If it still rocks then start loosening things up beginning with motor mounts, then top deck and check if it goes back to flat. I really doubt any RC company would take the kit back over this unless the chassis is clearly warped in a free state (nothing screwed to it). I haven't heard of that happening. Good Luck.