Originally Posted by
over gear
These are what I think is the most important hopups:
- Alloy spur holder
- 19T mid pulley. This really free up the belts
- Tamiya servo saver. the stock one feels sloppy.
- 4mm taller front and rear shock tower. All my springs are standard length. 3Racing's spring is shorter.
- Tamiya shocks. I really like Tamiya shocks and I happen to have a spare set in my box.
These are what I think is sort of important:
- Front and rear sway bar
- 4mm alloy wheel hex adaptor.
- Alloy rear bulk head. The camber link ball stud would move under high load.
- Vertical motor mount. The stock one require you to get the motor screw through the spur. I hate doing that.
- CF upper deck. It's require for the motor mount.
- You also need to trim the battery holder to make room for the front belt.
There are not necessary but I get it anyway:
- Front spool. I could have jam pack the gear diff.
- Front alloy bulk head.
Next on my wishlist is rear universals and a 416 bumper foam. The stock foam is sorta soft. I crash more than I should.
Id recommend getting alloy Wheel hex adaptors as most important. The stock plastic ones are not very smooth and if you use them long enough they melt creating even more friction