Today i've done some testing with 323Stock firmware and 6.5T V3 motor, the track was not sprayed with sugar because it rained the night before, so traction wasn't at its best, but good enough to test motors.
Ambient temperature was about 25°, track temp. 38°, max motor temp 60° without fans
Results were impressive, during the first runs i had too much power! So i toned down some settings to gain a better driveability.
Had no problem keeping up with 5.5 and 5.0 turns motors.
Here is were i started in the morning (too abrupt, difficult to drive) :
Stock rotor
Endbell timing - 5°
FDR - 8.5
4 - 7
9 - 30°
10 - 18°/0.1s
12 - 15°
13 - 5000
14 - 0.3s
15 - 500rpm/deg
and here the settings after various tests, i got a more linear feel of the power band
Stock rotor
Endbell timing - 5°
FDR - 8.5
4 - 7
9 - 25°
10 - 18°/0.1s
12 - 20°
13 - 6000
14 - 0.3s
15 - 700rpm/deg
Cheers!
BTW, this was the track, main straight is about 35m long
:
http://www.modellismo2002.it/pista.p...=580&width=895
P.s. Thanks Solara and sidecarphil1