R/C Tech Forums - View Single Post - Team Associated TC6 Thread
Thread: Team Associated TC6 Thread
View Single Post
Old 04-29-2011, 10:26 AM
  #2402  
Verndog
Tech Master
iTrader: (16)
 
Verndog's Avatar
 
Join Date: Jun 2007
Location: PPDBillet.com USA
Posts: 1,845
Trader Rating: 16 (100%+)
Default
Originally Posted by wtcc
Here you are:

Yes it will increase the width, but with thinner shims the width will stay the same, or am I wrong?

And one thing: It is not from AE. I measured every part several times and build it in 3D. Took some time and wasn't fun in the end, but after the TC5 had so many design failures when using LiPo I want to be prepared...
Wow...you must have over 60 hours into that. Did you use a CMM to measure or just layout on a rock with height gage and calipers?

If they are still effective down to 1mm thick you could keep width the same in most cases, except for fwd. rear where most use zero shim.
Verndog is offline  
Reply