Originally Posted by
Warren Weaver
i was trying to find hinge pins that are longer and drill the mounts so the pin sticks out slightly from end to end and use a set screw to hold them in place this will cause the mounts to stay in place,i will post that pic later with the hot bodies set up
Cool, thanks Warren. Went ahead and ordered some of their universals to compare to the Xray and Spec-R's. For now I have some Xray C hubs fitted up that I can test any of the 3 options with. I prefer to not bore the hard coating from the outdrives though so the Hot bodies have the edge there.
Your idea to drill out and extend is "on track", but I dont think there is enough wall thickness in the plastic pin block to hold the set screw reliably.