Originally posted by True R/C Racing
Well, Check ur mesh. If its too tight that can cause it too. Other than that i can't say much w/o it being in my hand. you mgith want to try going Lighter springs too on motor if your really worried
mesh is set correctly, just a slight play from the pinion to the spur. I acutally thought about putting the Trinity stock springs on it and taken the lightspeed ones off.
I did talk with Mark at LightSpeed and he said that sometimes one or 2 will slip by. What he said to do was to recut the comm, get some new springs and brushes and see if that fixes the problem.
Any word on those new Cobalt motors? Anyone know where I can read up on them?
Thanks to everyone that reponded. Not sure what i would have done without this coolarse site