Originally Posted by
Grenade10
Not sure it is that much, as when I use a receiver pack, I normally put back 300 - 400ma. Also look at the size of the wires to the servo and esc and they are very small so it will not flow many amps.
Originally Posted by
CypressMidWest
rx pack imo is still the only way to go. Why run something that steps existing voltage, rather than something that leaves all available voltage for the motor? I still don't understand the advantage of boosters, other than alleviating the need to charge an RX pack.........
Cypress, what are you normally drawing out of the rx pack? I normally pulled about 70-80mah with the tekin switch off. Is that what guys are normally pulling? And if so would that really effect anything substantial if going with the booster?
Grenade, do you usually leave the tekin switch turned on while running to
pull 300-400mah out?