I just posted these in the Z01T thread, but I figured I'd put them here too, since my Bulldog pics are here too. Good for comparison...I changed the color scheme up a bit too. I think this may be my new combination. Even though I work for John Deere, the green & yellow was getting a bit old.
Anyway, the Punisher fit MUCH better than the Bulldog. It's the correct width to drop right down over the side pods, The body mounts are in the stock location, and nothing is rubbing.
For anyone mounting one on the O'Donnell, trim the body about 3/8" below the molded in body line. It will cover the side pods more, and looks much better. Other than that, it was just mount / mark / trim / repeat, until I had everything like I wanted it. Now I can use this body as a template when I do future ones.
