Originally Posted by
I)arkness
hey guys,
trying to figure out the tamiya/spec r gear diff #42185
when its put together as per instructions, there is a slight gap in between the pully and outer case and when you spin it a few time you see oil leaking from screws and onto the pulley teeth.
my guess is that the gasket is to thick and doesn't allow the two half's to shut properly.
is it just me having this problem or has it been a known issue??
if someone could help out that would be and afternoon delight
cheers.
I Bought a Spec R a month or so back, went together easily, after around 25 runs, no signs of leaking what so ever.
It is friday, and although I have a coffee in hand, My "visialisation" skills are down atm lol all I can think of is the gears are not seated all the way down, not sure. Have a squiz at this
http://www.spec-r.com/specrr2/module...roducts_id=107
theres a video down the page I just found