Originally Posted by Bishop

New Xerun 10.5T has been fitted, ready to have some fun tomorrow night, though I did not like the look if it set vertical, I had a SP fitted so had the push on pins, but the wiring looked ugly with the pins at the top, and you could not read the marking on the can either, so a little creative wiring and it looks good now.

How OCD am I to spend half an hour doing that.

Got to say the stock solder on the ESC is hard to budge using a colder iron, I'm assuming it's lead free, had to break out the 40W to remove the original wires, for most work I only use a 18-20W iron.