R/C Tech Forums - View Single Post - Losi 2.0 starter box - belt snapping issue
Thread: Losi 2.0 starter box - belt snapping issue
View Single Post
Old 02-28-2011, 08:51 PM
  #14  
CHOAS
Tech Fanatic
 
CHOAS's Avatar
 
Join Date: Jun 2009
Location: Spring Mountain PA
Posts: 940
Default
Originally Posted by dash riprock
I dont know if this will help but I have a 2.0 version Losi starter box.The belt in it broke just after I bought it.I replaced it with this: http://cgi.ebay.ca/LOSI-8B-T-2-0-Sta...item3f050f0dd3 This belt is 100 times better than the original.Just make sure what box you have before hand if you plan on getting one of these belts.All I did when I found this belt was look up the Losi part number for it then search ebay for that number.Hope this helps.
I broke three stock belts in a week,well everone using my box to break in there engines because theirs were dead but anyway I bought one of these but have not tried it yet because I have not broke another belt in months.
Go figure. Oh yea when I went to get the third belt no one had them and everyone said backordered so I had to buy a new box.
CHOAS is offline  
Reply