Originally Posted by
teeforb
in regards of hooking it up...
pin 85 --------> lipo gnd
lipo pos --------> starter box switch ____/ ____ ---------> pin 86
lipo pos ---------> pin 30
pin 87 ----------> + on Motor
lipo gnd -----------> gnd of motor
is this correct?
I'm going to post here the link for the circuit and a photo of my installation, post them here if you wish:
h ttp://img64.imageshack.us/img64/7646/circuitocaixaus.jpg
h ttp://img27.imageshack.us/img27/8859/caixa1.jpg
About short-cycle, if you press the car in the box and for an instant you let the switch go off and them press the car again, your are wearing the relay contact, if you look at the graph you will see that the switch was let of in the instants t1, t2 and t3, but the motor keeps spinning avoiding the relay to open and close for 3 times. Is it clear?