Originally Posted by
Matt W
Hey,
Has anyone had trouble with the topdeck screws tightening after a few runs, sometimes they're almost impossible to get out!!
any ideas on solving this problem, perhaps grease or countersunk washers??
Hey Matt,
I'm using Alloy screws which solves the problem completely! I know what you mean though, i had the same problem. Titanium would probably be fine too!
Originally Posted by
olhipster1
Hey Steve.
are you running the HB?
been a while...hopefully you make it up Horsham soon.
Quick question
How does everyone like the servo saver that comes with the kit?
Not sure if I should change it out.
The kit one isn't the best, it has a strong spring, but it is short also, which causes it not to get good strong leverage on the steering rack. I went with a Tamiya Servo Saver, but using a 3 Racing Purple 18mm Alloy Horn, gives more leverage and is a great, strong servo saver!
Hope this helps!
Ryan.