Originally Posted by
Herrsavage
Yeah, it was a good bit.. I actually just found another short silver spacer from the Ofna shim kit, and shimmed up my second CB. This time I put three small bearings in up front and it shimmed MUCH easier.. Just one thin shim and the big kyosho washer-shim for the Fioroni clutch behind the bigger bearing.
This new CB had a slight deformity on the front edge-lip, so I had to kind of hammer the three front bearings in. Hope it's OK. Doesn't look like I'll be getting those front three bearings out either..
While I'm at it - what's the deal with a standard servo tray? I do not like the lay down style, for several reasons.. One, pain to change. Two, too many parts - one of which is missing from both my 1/7 kits.. Three, the servo is at more risk in a crash.. Etc.. Don't like the design.. Can you just throw in any old Jammin or Ofna servo tray? If so, which ones exactly?...
I use the maxvelocityracing radio tray and it is very good. Exactly what part are you missing?