Originally Posted by irgo

i found something,..
after previously found by someone on this thread,
with the boost Acceleration at 50rpm/Deg
as the method i was telling about how the noise come from 50rpm
fluctuation, was alright.

Then i started to investigate more deeper

Firmware that i tested again is :
V3.0_101224Stock
V3.0_110108Stock
V3.0_110119Stock
Those 3rd Generation Firmware had no Problem on the cases of 50rpm/Deg
noise, But, i found something is very wrong.

as i was always asking about the RPM Firmware Log, because of it's necessary need.

The Boost Start RPM, didn't working Correctly,
i have been investigate between all Start RPM 1000rpm~15000rpm.

It seem that All Started at always 1000RPM or the Lowest Boost Start,
The timing is active at that point, no matter we change to 15000rpm, it will always start at 1000rpm.

The result is All 3rd Generation Firmware Started too early all the time.

The difference Between the V3.0_110119Stock with (V3.0_110108Stock and V3.0_101224Stock)
is where the lower RPM Start.

But all of them had fail the Boost Start RPM.