Originally Posted by
got_nitro
Thanks guys.
I did read about using CA in the manual too. There's not a whole lot of material there to grind/drill away on the cover and install some kind of battery post in place of the screws so one could use small body clips.
I'll just have to use a dab of some gorilla glue or maybe some hot glue. I was even thinking about covering up the nut slot with a piece of tape just to make sure I don't lose them
Nothing worse then scrambling around at the last min before a race....
once the screws are in with the nuts put a drop of ca in there, nut won't fall out and plastic won't strip.