tdunster

I am new to the XeRun system so I just thought I'd jot down some information about my very limited experiences.

Hopefully somone might find something uselful.


I am using the 110119_Stock firmware with a Xerun 17.5t /60a combo.

Vehicle - Tamiya TB-03R
FDR - 7.00:1
Boost Timing = 30degrees
Turbo Slope Rate = 18degrees/0.1s
Turbo Timing = 20 degrees
Boost Start RPM = 5000
Turbo Delay = 0.4s
Timing ACC = 500

Results.

I set the car up this way because I wanted to do a lot of laps at a moderate pace without stressing the ESC or over-heating the motor.

After 15 mins of laping my local track the motor was at 140 degrees (Ambient temp was 80 degrees).

The car was a little docile through the infield sections but had reasonable top end once the Turbo came on.

Conclusions:

These settings are great if you just want to do some laps at a resonable pace and learn about how your car handles and reacts to tire or suspension changes. - without having to worry too much about over-heating.

However, if you are racing, the car will be need to have the FDR increased to around the 6.00:1 mark ( Speed) or, you will need to lower the boost RPM to 3000 Rpm, and increase the ACC to around 200 (faster acceleration).

EDIT: I have found that increasing acceleration increases terminal speed.


Cheers.