Originally Posted by
Shawn68z
Boost will normally lower the temperature of the motor. By starting with a conservating starting point, and moving to a more agressive seting if you need the extra power.
What are the settings you are using now? If you post your current configuration, we can make some suggestions.
Shawn.
Now without boost :
motor lrp x12 17.5t
esc HW xerun 120a
final gearratio 3.7
timing on motor +10
esc settings
punch - 7
timing - 2
Temprature after 6min about 150F, and its with stock firmware ( without turbo etc)
But in next competiton I'll need boost but I dont want to burn motor