R/C Tech Forums - View Single Post - Team Associated TC6 Thread
View Single Post
Old 01-09-2011, 03:28 PM
  #1397  
slicendice
Tech Regular
iTrader: (23)
 
slicendice's Avatar
 
Join Date: Dec 2010
Location: VA
Posts: 314
Trader Rating: 23 (100%+)
Default

hello new to touring cars I have just started playin around with my tc6 and wanted to implement Keven Herbert Timezone setup that i found on petit rc


I have a couple questions about the setup That I was wondering if anybody could help me with

1.Is the rear toe +3 degree in total does that mean +1.5degree on each rear wheel?

2. The rear camber link position used in the setup is 1A but when in that position the links do not adjust short enough to get the camber the setup calls for Do you need shorter links to use these positions?

3.The setup calls for "silver" ball studs do these studs have longer threads or is the neck of the ball stud itself longer


4.last in the setup it calls for arm mount shims in millimeters but the manual says they represent different degrees. Is it a typo on the setup sheet or should i measure the shims and go with what the setup says ?
Which arm mount shims that are used in this setup

ADDED thought maybe i am confusing arm mount shims with FWD or RWD mount shims or are they the same thing?

What are the RWD and FWD mount shims?

Last edited by slicendice; 01-09-2011 at 03:55 PM.
slicendice is offline