R/C Tech Forums - View Single Post - RC8B and RC8 parts
View Single Post
Old 12-31-2010, 11:03 AM
  #1  
jbrow1
Tech Elite
iTrader: (28)
 
Join Date: Oct 2004
Location: Michigan
Posts: 3,359
Trader Rating: 28 (100%+)
Default RC8B and RC8 parts

Prefer paypal - [email protected]
My ebay feedback under jbrow125

AE 2035 pipe and header that the stinger fell out of. I made a new stinger and epoxied it in. The Thundertiger pipe is the exact same pipe, brand new, never ran. I put the expoxy around the stinger so that one didn't fall out, but never ran it! So both pipes and manifold - $35 shipped.

JP3 pipe and manifold, no dents. Could use a good cleaning. Two new exhaust gaskets go with it. $30 shipped. -----------SOLD

Brand new never opened bearing kit for rc8, I assume it will be the same kit for the rc8b too. $15 shipped.----SOLD

I have a set of front and rear cvd's with bearings. There is no wear on the pins, and I never used them. I think they were pulled from a new kit for spares. Minor scrathing on parts of the tubing, but they are straight, and pins have no flat spots at all, and are factory. $20 shipped for either set,
Also have a set of centers with no bearings, 12 shipped --------ALL SOLD

Four chassis braces, the ones with links are used, the ae solid aluminum ones are new never used. $20 shipped for all four.

AE new never used adustable C and D plates $25 shipped for both

Front or rear ae diff never used, pulled from new kit $20 shipped _-------SOLD


Last edited by jbrow1; 12-31-2010 at 03:27 PM.
jbrow1 is offline