R/C Tech Forums - View Single Post - Hyper TT 4wd 1/10th Truggy Thread
View Single Post
Old 11-24-2010, 08:08 AM
  #887  
ambryatim
Tech Adept
iTrader: (19)
 
ambryatim's Avatar
 
Join Date: Dec 2007
Location: Corinth, TX
Posts: 245
Trader Rating: 19 (100%+)
Default

Ok, So I installed my new "drag link" and here are some pics and explanations.


First You need to remove the upper hinge pin bracket.


Once off, you can just pull the bell cranks off and the old wire!!


I just rotated the arm to gain access to the under side of where the wire used to go thru. And installed the ball stud with spacers.


You should have these spacers in with the new body clips that came with the truck. I used all (4) of them one thick and one thin per side and they were just shy of 4mm thick.


Side view


Servo Saver side






When assembling the ball cups onto the turnbuckle, just screw the ball cup up to the end of the threads.


Tried to get a good picture of it installed.


After you get the ball studs installed reassemble everything....now would be a good time to replace the bell crank bushings with bearings. Then once assembled snap the new drag link in place and enjoy.

Last edited by ambryatim; 11-24-2010 at 08:40 AM. Reason: Added Photo
ambryatim is offline