View Single Post
Old 11-05-2010, 07:07 PM  
cheapskate.brok
Tech Elite
 
Join Date: Jan 2009
Posts: 2,051
Trader Rating: 10 (100%+)
Default

Quote:
Originally Posted by BrodieMan View Post
I had the same issue, the manual lists a slightly different pin for the LCD's but mine were the same as the hex pins. I ran a few packs running tight turns and being easy on the throttle.
Man, I don't wanna break anything. It's like a solid axle! Dammit, I'll see if I can get some substitutes.

Quote:
Originally Posted by hacker View Post
I cannot even fit a 46mm wide IP3800 lipo in, as the 3 small screws that hold the drive pulley in place are 'raised' due to the countersink holes not deep enough. I dont know what you guys are doing, grind the heads flat, or deepen the countersunk holes.
Grind the hard case. Yeah I know, disappointing

Extremely nice to look at tho (the car!)
cheapskate.brok is offline   Reply With Quote