View Single Post
Old 11-05-2010, 02:18 PM  
padailey
Tech Master
 
padailey's Avatar
 
Join Date: Nov 2005
Location: Council Bluffs, IA
Posts: 1,603
Trader Rating: 11 (100%+)
Default

Quote:
Originally Posted by hacker View Post
just finished my build, lucky I ordered 2 kits, as I needed parts as there were 3x parts that were doubled up, which meant 3 correct parts had to be robbed from the extra kit. Losi need to good kick in the head as their QC sucks , lets not get started in my offroad losi cars

I cannot even fit a 46mm wide IP3800 lipo in, as the 3 small screws that hold the drive pulley in place are 'raised' due to the countersink holes not deep enough. I dont know what you guys are doing, grind the heads flat, or deepen the countersunk holes.

so back on the shelf until my FF layshaft arrives.

Very disappointing Losi!
Hmmm I have a IP3800 in mine. Screws were not an issue but there were some nubs I had to knock off the battery side of the pulley so it would not rub.
__________________
www.hobbyplexraceway.com

Tamiya TRF417X (Lion's Automotive GTR)
Tamiya TRF416X
Tamiya F104W MP6/4 converted to F104X1 (Renault R30)
padailey is offline   Reply With Quote