Originally Posted by
Locum51
I'll back up the full synthetic tranny fluid, (although i used castrol)
I dipped one corner of a paper towel in the bottle until about 1 in is saturated....then just use that corner to wipe around the sleeve and on top of the piston. Just rotate the whole assembly a couple of times and your set. *This might not be the best idea but it works.*
*It's kind of similar to coating a cylinder block after a engine rebuild.
That works except I use cheese cloth as it's non abrasive(I'm sort of weird that way). We use it when we are working with film in the graphic arts industry. It doesn't scratch the emulsion when cleaning the mylar.