Originally Posted by
On-Point Racing
The front end holes are 2mm wider per side and the chassis is wider there to give more support outside of the holes.
Where the links attach to the chassis the chassis is 1.5mm narrower per side and where the battery goes is 2.75mm narrower per side.
Here is a picture if the battery holders on the chassis.
Lets get off this super wide page...
I built a little on the new chassis tonight. The first thing that hit me was how perfect the countersinks are. I hate when the screws stick out from the chassis bottom or get swallowed up by over zealous (read weakened) countersinks. The on-point chassis countersinks sit the screws just a fraction below the chassis surface.
Rear pod and links lined up perfect along with all the other screw holes.