R/C Tech Forums - View Single Post - jamming X2 CRT?
Thread: jamming X2 CRT?
View Single Post
Old 09-20-2010, 08:18 AM
  #133  
GravityJunkie
Tech Regular
iTrader: (9)
 
GravityJunkie's Avatar
 
Join Date: May 2008
Posts: 264
Trader Rating: 9 (100%+)
Default

I have a set of 12mm that I haven't run -- 12mm gets you close to the stock width.

I've run without extenders and now I'm currently running with the 6mm extenders. However, I shaved a mm or two off to limit rubbing, so it's a little less. With no extenders, I had problems with traction rolls. And it was a little too twitchy for my taste. The 6mm seemed about right for me, faster turn than stock (but not too bad) and the traction rolls were reduced.

Like I said, I had to file the extenders down to make'em fit. I also placed a .2mm washer behind the extenders to help keep down rubbing. It was well worth it, I'm really digging the 6mm extenders.
GravityJunkie is offline