Yeah thanks for that, I went for the blob to start with!
I've got them soaking in WD40 at the moment..
Won't do that again..
What else should I thread lock on the photon?
done so far:
Middle Pulley mount,
Sway bar set screws..
CV set screws
how about the spool?
Originally Posted by
paraletic
You put to much on
you only need the smallest amount ie: a very thin smear, not a blob
get some motor spray and spray it in the cv, pull it apart then allow it to soak in a small container with some motor spray for a bit
then clean it with a clean cloth
assemble with smallest amount
once is assembled get a clean rag an wipe any residue off from the cv an ya set to go