Originally Posted by
mrod
Hey rtype, I have a question for you. What susspension blocks did you use so that you could fit the 46 mm universals. I have an aluminum diff and the diff nut side binds into the end of the bone, and I am using 42mm half shafts. I checked to make sure the diff was installed properly and it is, the only thing that I can think of is that the 1xd set up is to narrow. What do you think and what did you use?
Thanks, any help will be appreciated.
I'm using a 1xd in the front/front and the split 1xd/1d in the front/rear. Also, I only used a half sponge on one side and nothing on the other. As for the diff nut binding, I had the same problem and fixed it by putting the diff nut/holder on the other side (maybe it's in the instructions but I didn't see it lol) In any event, gotta go get my pyro on.
Happy 4th everybody.