Originally Posted by
1101
Hi there.
I'm putting a M05Pro together(still no locking hex-hubs!! I thought this was a high end version)
Ive never figured out the servo saver. Are all 3 springs supposed to go in it??
Is it even needed. with all 3 springs it seems almost solid. Im sure something else will give out before can do its 'saving' job ?? (did on my M03, ripped out ball connector)
I hate to ask about servos here again, but Is a Futaba 3003 good enough??
I'd rather used my spare Spektrum(JR??) servo, but none of the Tamiya servo parts fit its spline- any ideas on how to use a Spektrum servo ??
cheers
You use all 3 spring clips otherwise the steering will wander under load. 2 gold on the inside and the black on the outside. It is supposed to be near solid. It is designed as a "servo saver" . It saves the servo gears from being stripped when under extreme load (a crash or hit)