Originally Posted by
jmaxey51
just to add the 5955 is the 7955 now, same exact servo.
Wrong...the 5955 has older circuitry VS the 7955 which has G2 Circuitry....so They are Not the exact same servo's.
Originally Posted by
vivo quevas
Ace/AE's are notorious for wear gear set's and top cases......Ti Vs Brass....I know which ill take every time.
Originally Posted by
tc5 man
man nobody on here has used, the hs-7954 sh high voltage servo for the truggy it isnt bad at all lots of, torque and speed and diginal and smooth. i use it for the steering of corse on the truggy.
it has a heat sink around it too.
Again Ti Vs Steel...I'll take the Ti Any day of the week
Originally Posted by
mksmlss
7955 only has a 4.8 to 6.0 volt operating range. Are people still running 7.4 volts through them with no problems?
100% capable of running unregulated.