R/C Tech Forums - View Single Post - can a to rich high speed needle
View Single Post
Old 05-04-2010, 01:44 PM
  #31  
ScottyM
Tech Elite
iTrader: (27)
 
ScottyM's Avatar
 
Join Date: May 2009
Location: Miami OK
Posts: 3,149
Trader Rating: 27 (100%+)
Default

Originally Posted by houston
CHANGE THE PLUG!!

what engine is it? some run very well at the low temps and some don't, 1.5 gallons it should be broke in fully by now . if you are happy with the power delivery why mess with it ? the runtimes tell me your tune is a little off though
No Offense intended toward psychoB4 at all, but he could be driving on the throttle a little to much too.. I've noticed I loose anywhere from 1-3 minutes depending on how hard I am driving.. Obviously the harder I drive it the lower the run time gets.. Only a few engines like the low 200 range, most are sirio based.. I run a Extech .24 on my truggy and it stays around 200 most of the time, and I get near 12 minutes w/JP6 pipe. But I have run it dry in 8.5minutes before.. I was driving really hard and was upside down more than usual..
ScottyM is offline