Originally Posted by
nrtv20
what voltage regulater does everyone run? I want to use lipofor rx pack too! I just struggle with bad or old nmh batts and want to simplify my set up.
I'm running the Losi 2S pack and regulator. No issues thus far.
In the Jammin' I put the reg. in the rear battery compartment, mounted vertical.
In a Losi radio box; I put the reg. up front, stood vertical next to the receiver on the inboard side where it's a little deeper/taller in the box.
I don't use a switch setup. I put mini-Deans plugs on the battery and receiver extension wire and plug/unplug it right next to/by the throttle servo. Wires are just long enough to grab but don't move/go anywhere else while racing.