Originally Posted by
jmackani
Anyone else tried the brake release springs from answer rc? I put them on to replace the fuel tubing on my losi's and I am not sure that is the correct installation. One spring per disc did not seem to be enough so we stuck two on. With two though, they can bind on each other. So I am thinking of trying the fuel tubing with one spring on each. Does anyone have other suggestions?
Are you using them on the brake discs or the throttle brake linkage...
I am using the ofna ones as well and will continue to use them....i had to put 2.6mm washers between the brake plates and springs
if you are looking for springs for the throttle and brake...try kyosho mp9 linkage
or use .024 or .022 associated pan car front springs...work good but need replaced after 3 or 4 gal. as they loose the tension from heat or cycles
After reading your post again...try the 2.6mm washers...