R/C Tech Forums - View Single Post - 1S setups with 2s receiver packs… Bad!
Thread: 1S setups with 2s receiver packs… Bad!
View Single Post
Old 03-02-2010, 06:51 PM
  #10  
bjgarner43
Tech Rookie
 
Join Date: Jan 2010
Posts: 4
Default
Originally Posted by TeamTekin
Normally we would remove the red wire from the esc receiver plug and we would not care what voltage the receiver pack is, but in this case we are leaving the red wire in place so we can use the receiver pack voltage.
I'm not clear on this sentence.

I am planning on trying a 1S Lipo system on Wednesday. My intent was to tape the ESC Power Switch in the OFF position and plug a 6 volt 5 cell receiver pack right into the receiver BATT plug.

Will this work OK, or should I be doing something more?

Thanks!
bjgarner43 is offline  
Reply