R/C Tech Forums - View Single Post - Hot Bodies Cyclone
Thread: Hot Bodies Cyclone
View Single Post
Old 01-13-2010, 10:26 AM
  #18277  
JR007
Tech Master
 
Join Date: Apr 2008
Location: Christchurch, NZ
Posts: 1,063
Default
Originally Posted by AGNO
If you are interested ... I have used with good results in category 17.5 foam asphalt fol setup:

Front
Spring Xray 30lb Light purple
Oil 50wt
Piston 2 Hole 1.2mm
Sway Bar 1.6mm
Camber link shim 2mm
1mm below the pivot suspension
0 ° pivot toe

Rear
Spring 17.5lb Xray white
Oil 30wt
Piston 2 Hole 1.2mm
No sway bar
0mm Camber link
1mm below the pivot suspension
3 ° pivot toe

Tire

Front and rear 37shore

Important!
Min.57mm tire diameter, maximum 60 mm
That's great thank, and actually not too far from where i'm set.
With the spacer below the pivot block, do you also have a spacer under the toe block?, or do you run with anti-squat and dive?
JR007 is offline  
Reply