View Single Post
Old 12-29-2009, 08:40 AM  
Integra
Tech Lord
 
Integra's Avatar
 
Join Date: Dec 2006
Posts: 12,484
Trader Rating: 8 (100%+)
Send a message via MSN to Integra
Default

Quote:
Originally Posted by butch man View Post
I know its alittle late but tool truck small allens are no good when compaired to RC specific allen drivers. No you can not special order true hardened allens off tool trucks in any form T,L,or socket.The ones actually made by the tool truck companys & not just rebadged KD or Lyle are forged & while forged steel tools are hard they are no where near as hard as the drill bit blanks many RC specific tools are made from.

You can still cut glass with the decade old MIP drivers I have or the Bullit ones that are 4-5 years old.You cant do that with brand new Snapon tools.
Please dont take this as picking on tool truck tools,I have well over $150,000. in snapon & matco tools & boxes that I use every day to feed my family for the last 15 years.

For 1.5,2.0,2.5,3.0mm hex drivers tool trucks are a frustrating waste of money.

well said butch.

Ive personally seen/tried the snapon big long red handeled 2/2.5mm and it was a joke.....can you say twisty twisty.
__________________
TNS Driver - Radio Post - Blue Groove Apparel - Team Panther - Hitec - Losi - W.E.D. Paint - Clockwork Fuel - Competition Heat - SUMO Racing - Tekin - Team Terribles - M2C Racing - Matrix Concepts - Kal Gard - BuKu Power - DE Racing -
Integra is offline   Reply With Quote