Originally Posted by
Tate72
I need some advice, I have got a used 8ight to where the back of the chassis is worn down thin. It's not worn down all the way but I had to cut grooves in the back 2 screws to get them out. I would say it's less than half left. So my question is, until I get a new chassis for it will these work for now?
http://www.amainhobbies.com/product_...si-8-8T-20-20T
Also I will ask here to. I can't seem to find a back plate on A-Main that I can use for the losi 427 motor to convert to a bump box. Does anybody know if the make one or where I can locate one at?
For the rear you can try the plates I would suggest using shoe-glue since the chasis is worn I would go with the older version not the new version since your chasis is worn they tend to bend easier since your chassis isnt true. Normal the tail wears the most making it hard too fasten since the front side is thicker.