Originally Posted by koreanassasom

last year i ran rc8 and rc8t on a ofna truggy box. i set the pegs so there were in a position to work on both truggy and buggy then all i had to do was move the two plates wider for truggy and shorter for buggy i set the plates for truggy then i drilled the top of the starter box and installed screws with the finish washers for buggy so when i slid the plates closer the screws stop the plates at the exact spot needed. notice the screws that stop the plates when i slide them inward so at max plate width set for truggy slide to screws set to buggy. hope this helps lol