Originally Posted by Hi-LowBlow

Hi Ali,

The difference between using the 2.0 deg blocks for FF/FR and the stock block is that the hinge pin width. With using 2.0 deg block for both FF/FR, we can widen the hinge pin width to 44.8mm. (Stock one is 42mm)

The benefit on using wider block is that we will be able to go softer overall but still not much roll. I can also say the front end will have more stability that will eventually generates more crispier turn in.

We have been trying this for long time and getting very good result with it.
To do this, you will have to make another two holes on the chassis to put the block on, and you will have to dremel the block due to the interference with both steering linkage and front drive belt.

You can also choose the width 43mm by using 1.5 deg block.

Let me know if you need further info.
Thank you.