R/C Tech Forums - View Single Post - does anyone make extended hubs for jammin'?

12-15-2009, 06:27 PM

#7

DOMIT

Tech Elite

iTrader: (1)

Join Date: Oct 2007

Location: Fort Worth, Texas, USA, North America, Earth, Solar System, Milky Way Galaxy, Universe

Posts: 4,034

Trader Rating: 1 (100%+)

Quote:

Originally Posted by boxhead

Domit, I am very new to all of this, I race a XB8TQ and was advised by one of the local guys who races XB808 (upgraded from XB8TQ) to buy the offset hubs.
So are you saying I can buy these ones.
http://www.amainhobbies.com/product_...el-Hubs-2mm-X5

As opposed to these ones?
http://www.amainhobbies.com/product_...-Hard-Coated-2

If I fit the Mugen ones will I need to buy the Mugen wheel nuts (as opposed to just reusing my Xray ones) and do I use the Xray pins or do I need to buy Mugen pins?

Thanks in advance.

Those will work and are of the same width. And there is no such thing as "Hudy Aluminum..." (Hudy STEEL is superior to the steel used in the drivetrain of other cars.)

I run those exact ones (the Mugen ones) on my XT8 I believe.

Mugen and XRAY are the same thread on wheel nuts. No need to change. Pins are the same size, use what you have.

Good luck finding a way to remove the ice dispensers in front of the rear wheels on that car. LOL It will definitely teach you to drive!

Reply