R/C Tech Forums - View Single Post - making you servo strongerr!
View Single Post
Old 12-09-2009, 08:48 AM
  #6  
brofroe
Tech Fanatic
iTrader: (20)
 
brofroe's Avatar
 
Join Date: May 2008
Location: Cleveland, TN
Posts: 877
Trader Rating: 20 (100%+)
Default

I haven't tried applying more than 6v to my system, but i think it has more to do with epa being set to not overload the servos. I say this because i had the bec fail in my MMM once and sent full 3S 11.1v to my steering servo. It was FAST but did no damage. I didn't run it long but i did for a minute or two. After that i used the servo for a long time to come until i upgraded. It was a chaep servo and it survived 11.1V. Keep in mind I had my epa set properly. Hope this helps.
brofroe is offline