Thank you for help.
I purchased Muchmore bearing lube a few days ago (before i've read plod's post). Is it also good (you said that O'Lube is)? How much lube should i pour into a bearing (1/2 of its thickness? more? less?)?
What about ProTek bearings? They are also cheap but what about their quality?
This is not a question connected to this thread but I didn't want to start another one for this simple question...
Is there any difference: (1/2 offset wheel + 0 offset hex) vs. (0 offset wheel + 1/2 offset hex)? I mean for the bearings, suspension arms, etc.
Last edited by Donat; 11-11-2009 at 01:46 PM.
Reason: spelling mistake