Originally Posted by
leonardiw
thx for your detail reply, i'm using titan setup tools to measure it
just check on both left & right plastic uprights, they are in good condition but the previous owner put different shim on each side
on left uprights Front 0.2+0.3, Rear 0.5 (non tamiya spacer)
on right uprights Front 0.55, Rear 0.55 (tamiya kit spacer thickness is not exactly 0.5mm as stated on the manual according to my digital caliper it's 0.55
)
will this affect rear toe in measurement ?
TIA
Leonardi
Check that your hinge pins aren't bent, and that your toe blocks are straight. That'll be for me the first things to check on a 2nd hand car. Incidentally I have just picked a 2nd hand 416 and of course, 3 out of the 4 blocks were bent. It doesn't matter since they're not the ones I am using (put the short arms directly on it and C-C, XA-E).