Originally Posted by
Scottmisfits
I don't use the droop gauge either. I use a down travel measurement. I set my ride height and then set the down travel.
Let's say I have a 5mm ride height and want 2mm of down travel. I use two ride height gauges and block the chassis up at 7mm (5mm+2mm). Now I adjust the droop screws until the tires "just" touch the set up board.
i use setup board and integy ride height/droop gauge set the car flat on the board then i go 5mm in the front 3mm in rear so after you put the tires back on you have a droop of 10mm or 5mm above ride height in the front and 8mm or 3mm above ride height in the rear