Originally Posted by
sidecarphil1
really ???
i have 0.5 mm on the front block and 1mm on the rear split blocks
does this not give me 0.5mm of anti dive still ??
thats correct phil
JCarr.
You say with a 3mm and 5mm spacer? Exactly what spacers where were, cause it sounds like your using a lot of spacers in there!!
If you've got the manual, have a look at the front end build. An italic outlined 1C should go on flat on the chassis, whilst an italic outlined 1C should be flipped with 3mm spacers in the rear position.
This gives flat hinge pins, and 0° anti-dive.
Cheers
Ed