Originally Posted by
Goingfast
No I didn't pulled a power wire out of the esc..
I'm using Tekin RS Pro
Franko, you need to make sure that you are running the version 200 software and check the 1S box. Also move the voltage cutoff slider all the way to the top and adjust it to 3v (not #3 on the slider but to the top until it gives you the ability to adjust the cutoff voltage). Make sure the booster is wired to the speedo per the directions and plugged into the RX. Make sure no wires are removed from the ESC plug that goes into the receiver. Both the Booster switch and the ESC switch needs to be turned on. First the booster switch and then the ESC switch. If all else fails bring it to the Hanger on the 28th. I will have my lap top there.