Originally Posted by
da_John_wee
I think you mean "Track" or "width" not an wheel base, the wheel base is distance between front axle to rear axle.
I think Rear track is maxed with medium aluminum hexes.
also hole on arm is reffed as inside and outside holes and a inside hole is designed for use a offset rear hub such as LOSA9868
I tried them at carpet track with series of tight 90deg turns and car was squaring up so much on the corner I can't take any line on-power.
these offset was made for XXX-S which have longer arms than the type-R, I always run offset hubs on my XXX-S, I don't think I will ever use offset on the type-R again.
hope this help
yes, track width is what I was trying to refer to.. After posting, I did a little research and discovered what the short and long settings were. I read the manual and found at the back that the rear is maxed at 190. I am going to check this out by using my setup station..
will let you know.